![]() ![]() Therefore, turntable styli are not universal every turntable comes with a specific needle. So when upgrading your turntable, you can install a new high-end stylus that can improve your listening experience. Remember, low-end record players, come with a permanent cartridge that supports needle replacement. Luckily, there is a perfect replacement that you can install in your record player. These cartridges come with either a permanent or removable stylus therefore, each turntable brand has a unique needle. The cartridge converts the vibrations to an electric signal amplified and converted to sound by the amplifier and speakers.īoth the magnetic coil and moving magnet cartridges use a coil and a magnet, vibrating in unison with the needle assembly. The cartridges are electromagnetic generators that convert the vibration (mechanical movement) picked by the stylus. And depending on the cartridge, record players can be grouped as the moving coil and magnet cartridges. Do All Record Players Use the Same Needle?Īll turntables come with many components that work together to convert the vibrations to music. After all, high-end turntables don’t use the same needles as the low-end record players. Therefore I am sure you are wondering, do record players use the same needles? Technology has changed over the years with better and reliable needles produced. They were long, so you had to use them until they were too short to be used. Produced by Victor, these needles played between 100 to 300 records before being replaced. The shortage of steel in 1916 forced people to turn to tungs-tone needles. Therefore, record players used the same needle in the past, so you had to pick which type of music you wanted to listen to and enjoy. The longer stylus produced muted softer tones while the short, thick ones made loud, intense sounds. These needles varied in length and thickness. Plus, they were sold in small tins and packets. Luckily, the steel needles were relatively cheap in fact, you could get a packet of 500 needles for only 50 American cents. Therefore, the adverts asked folks to replace the steel needle after listening to each side of the record player, which meant that you had to purchase lots of needles at once. ![]() Unfortunately, steel needles needed replacement regularly, thanks to the high wear and tear rate. In fact, the most preferred materials for turntable needles over the years have been tungsten, copper, steel, and bamboo, among others. The early record players used short-lived needles besides the diamond and sapphire stylus. Manufacturers have used different materials to make the needle over the years in fact, Thomas Edison introduced a diamond stylus in 1910 and a sapphire one in 1892. Remember, a damaged needle can degrade the quality of sound produced and damage the vinyl records’ grooves. The stylus is resistant to wear therefore, it can take years before you ever have to replace your turntable’s needle or cartridge.Secondly, the needle does not break the vinyl record despite the amount of force used while on the record’s grooves.The needle faithfully follows the vinyl record’s groove contour and picks the transmitted vibrations.Luckily, there are three desired characteristics of these needles: ![]() Unfortunately, this component is subjected to hard wear thanks to the pressure it applies to the grooves. The needle is the only part of the turntable that comes into contact with the vinyl record. In fact, the names needle and stylus are used most of the time interchangeably. A stylus is a uniquely shaped needle that rests on the record player’s grooves and helps pick the vibrations. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |